North America |
Log Into Your Account
Go to Magellan Active
Manuals and Software Downloads
Warranty, Repairs & Returns
Magellan 60-Day Map Guarantee
Please ensure that your unit is running the latest
Search Support Center:
-- Entire Support Site --
Knowledgebase and FAQs
Downloads and Manuals
How to assemble the Magellan Sun Shade
To assemble your Magellan Sun Shade please perform the following steps:
Lay out both items that were included in the package.
Take the wire assembly with the short side facing up
Pull the rubber wire coating back to where the assembly starts to bend backwards so it reveals the bare wire
Slide the exposed bare wire into the open slot of the sun shade and align the wires to the open notches on the shade and pinch then towards the middle slightly so the exposed wire fits into the notches and clip in
Slide the GPS inbetween the wire assembly and the sun shade
18 Jun 2013 10:02 PM
This article was helpful
This article was not helpful
How can we improve this article?
If you would like to comment on this entry, please use the form below. Comments may be queued for moderation, and will not be published until approved.
Image verification required
Please enter the characters that appear to the right in the space provided. This is just to verify that you are a human.
E-mail Address: (optional)
Kayako Skin by SupportSkins.com
Become a Reseller
In the News
Tradeshows and Events
©2013 MiTAC International Corporation 2013 All rights reserved.